Rigol DM3063 User Manual page 58

RIGOL
Ratio Measurement
Ratio measurement is used to measure the ratio of 2 directions DC voltage signal.
Ratio measurement is only for measuring DC voltage.
Press Ratio , enter the menu shown below:
Table 2-7 Ratio Measurement Menu Explanation
Function Menu
ON
OFF
The method of the radio measurement:
DC Voltage
DC
Ratio=
DC Re frenceVaol
DC Reference Voltage
(1). Measuring Sense Terminal, for measuring reference DC voltage. Default range
option is auto.
(2). Measuring Input Terminal, for measuring DC voltage. The measuring voltage
scope is 0V~1000V
(3). Input LO Terminal and Sense LO Terminal must have a common reference
value, and the voltage difference cannot surpass ±2V.
2-8
Figure 2-6
Open the Ratio Measurement Function
Close the Ratio Measurement Function
Save all changes, back to a higher level menu.
⋅
Voltage
tage
© Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
Explanation