Example 5: Limit Test - Rigol DM3063 User Manual

RIGOL

Example 5: Limit Test

Do these steps as follows:
1. Connect test leads as Chapter 1 introduced. Now we want to measure an AC
Voltage. Connect test leads as shown:
2. Press button, select DC Voltage measurement function. Choose a correct
range.
3. Set the Limit measurement function parameters.
(1). Press Limit
(2). Press Limit
(3). Press Limit
(4). Press , save all changes, back to a higher level menu.
4. Start Total measurement.
(1). Press ON , turn on Limit measurement function.
(2). Press , finish this setting.
5. Lead test leads into circuit, starts to measurement.
3-6
Figure 3-9
High , Set up the upper value.
Low , Set up the lower value.
OverR, Set up the overload value.
Figure 3-10
© Copyright RIGOL Technologies, Inc. 2007.
User Manual for DM3000 Series
DC Voltage