To Set Up Triggering Parameter Function - Rigol DM3063 User Manual

RIGOL

To Set Up Triggering Parameter Function

The DM3000 triggering system allows you to generate triggers either manually or
automatically, take multiple readings per trigger. The DM3000 also allows you to set
a level for internal triggering, and to set up pre-triggering.
Selecting a Trigger Source
Specify the source from which the multimeter will accept a trigger. The power–on
default is auto triggering from the front panel. Several types of triggering are
described in the sections that follow.
The power–on trigger default mode was auto trigger (RUN) mode. Press
to the hold trigger mode. Press
reading is taken, and another reading is taken each time you press
hardware trigger is received on the Ext Trig connector.
Table 2-15 Trigger Parameters Setting Menu Function Explanation
Function
Menu
Auto
Single
Ext
VMC
© Copyright RIGOL Technologies, Inc. 2007.
to go to the single trigger mode. A single
Figure 2-18
Explanation
Setting system fixed time Auto trigger and reading
Hold scope parameters.
Setting Single manual trigger parameter.
Setting the reading Hold scope.
Setting the pulse width of sampling ending signal.
Save all changes, back to a higher level menu.
User Manual for DM3000 Series
to go
, or when a
2-19