RIGOL
Basic measurement:
1. Connect test leads as Figure 2-7 shown. Red test leads connect the HI Terminal,
Black test leads connect the LO Terminal.
2. Press
to select the DC Voltage measurement function.
3. According to the voltage measuring scope, choose the correct range.
4. Set up the DC Ratio Measurement.
Press
Ratio
Press
to save all changes, back to a higher level menu.
5. Lead test leads into circuit, starts to measurement.
© Copyright RIGOL Technologies, Inc. 2007.
On , to start the DC Ratio Measurement.
Voltage
Figure 2-7
Ratio Measurement instruction chart
User Manual for DM3000 Series
Signal
Reference
Voltage
2-9