Sample Configurations; Vrrp For An Ipv4 Configuration - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

The default is 0.

Sample Configurations

Before you set up VRRP, review the following sample configurations.

The following configuration shows how to enable IPv4 VRRP. This example does not contain comprehensive directions and is intended to

provide guidance for only a typical VRRP configuration. You can copy and paste from the example to your CLI. To support your own IP

addresses, interfaces, names, and so on, be sure that you make the necessary changes. The VRRP topology was created using the CLI

configuration shown in the following example.

Figure 148. VRRP for IPv4 Topology

Virtual Router Redundancy Protocol (VRRP)