Dell S6100 Configuration Manual page 259

Configuring DCBx Globally on the Switch
To globally configure the DCBx operation on a switch, follow these steps.
1 Enter Global Configuration mode.
EXEC PRIVILEGE mode
configure
2 Enter LLDP Configuration mode to enable DCBx operation.
CONFIGURATION mode
[no] protocol lldp
3 Configure the DCBx version used on all interfaces not already configured to exchange DCB information.
PROTOCOL LLDP mode
[no] DCBx version {auto | cee | cin | ieee-v2.5}
• auto: configures all ports to operate using the DCBx version received from a peer.
• cee: configures a port to use CEE (Intel 1.01). cin configures a port to use Cisco-Intel-Nuova (DCBx 1.0).
• ieee-v2.5: configures a port to use IEEE 802.1Qaz (Draft 2.5).
The default is Auto.
NOTE: To configure the DCBx port role the interfaces use to exchange DCB information, use the DCBx port-role
command in INTERFACE Configuration mode (Step 3).
4 Configure the PFC and ETS TLVs that advertise on unconfigured interfaces with a manual port-role.
PROTOCOL LLDP mode
[no] advertise DCBx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc] [ets-conf |
ets-reco | pfc]
• ets-conf: enables transmission of ETS Configuration TLVs.
• ets-reco: enables transmission of ETS Recommend TLVs.
• pfc: enables transmission of PFC TLVs.
NOTE: You can configure the transmission of more than one TLV type at a time. You can only enable ETS recommend
TLVs (ets-reco) if you enable ETS configuration TLVs (ets-conf). To disable TLV transmission, use the no form of
the command; for example, no advertise DCBx-tlv pfc ets-reco.
The default is All TLV types are enabled.
5 Configure the Application Priority TLVs that advertise on unconfigured interfaces with a manual port-role.
PROTOCOL LLDP mode
[no] advertise DCBx-appln-tlv {fcoe | iscsi}
• fcoe: enables the advertisement of FCoE in Application Priority TLVs.
• iscsi: enables the advertisement of iSCSI in Application Priority TLVs.
The default is Application Priority TLVs are enabled and advertise FCoE and iSCSI.
NOTE: To disable TLV transmission, use the no form of the command; for example, no advertise DCBx-appln-
tlv iscsi.
Data Center Bridging (DCB) 259