Dell S6100 Configuration Manual page 567

Tracking Route Reachability
Use the following commands to configure object tracking on the reachability of an IPv4 or IPv6 route.
To remove object tracking, use the no track object-id command.
1 Configure object tracking on the reachability of an IPv4 or IPv6 route.
CONFIGURATION mode
track object-id {ip route ip-address/prefix-len | ipv6 route ipv6-address/prefix-len}
reachability [vrf vrf-name]
Valid object IDs are from 1 to 65535.
Enter an IPv4 address in dotted decimal format; valid IPv4 prefix lengths are from / 0 to /32.
Enter an IPv6 address in X:X:X:X::X format; valid IPv6 prefix lengths are from / 0 to /128.
(Optional) E-Series only: For an IPv4 route, you can enter a VRF name to specify the virtual routing table to which the tracked route
belongs.
2 (Optional) Configure the time delay used before communicating a change in the status of a tracked route.
OBJECT TRACKING mode
delay {[up seconds] [down seconds]}
Valid delay times are from 0 to 180 seconds.
The default is 0.
3 (Optional) Identify the tracked object with a text description.
OBJECT TRACKING mode
description text
The text string can be up to 80 characters.
4 (Optional) Display the tracking configuration and the tracked object's status.
EXEC Privilege mode
show track object-id
Examples of IPv4 and IPv6 Tracking Route Reachability
Examples of IPv4 and IPv6 Tracking Route Reachability
The following example configures object tracking on the reachability of an IPv4 route:
Dell(conf)#track 104 ip route 10.0.0.0/8 reachability
Dell(conf-track-104)#delay up 20 down 10
Dell(conf-track-104)#end
Dell#show track 104
Track 104
IP route 10.0.0.0/8 reachability
Reachability is Down (route not in route table)
2 changes, last change 00:02:49
Tracked by:
Dell#configure
Dell(conf)#track 4 ip route 3.1.1.0/24 reachability vrf
vrf1
Object Tracking 567