Dell S6100 Configuration Manual page 654

The following example shows using the show vlan private-vlan mapping command.
S50-1#show vlan private-vlan mapping
Private Vlan:
Primary : 4000
Isolated : 4003
Community : 4001
NOTE: In the following example, notice the addition of the PVLAN codes – P, I, and C – in the left column.
The following example shows viewing the VLAN status.
S50V#show vlan
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description
* 1 Inactive
100 Inactive
P 200 Inactive primary VLAN in PVLAN
I 201 Inactive isolated VLAN in VLAN 200 T Te 1/21/1
The following example shows viewing a private VLAN configuration.
!
interface TenGigabitEthernet 1/3/1
no ip address
switchport
switchport mode private-vlan promiscuous
no shutdown
!
interface TenGigabitEthernet 1/4/1
no ip address
switchport
switchport mode private-vlan host
no shutdown
!
interface TenGigabitEthernet 1/5/1
no ip address
switchport
switchport mode private-vlan host
no shutdown
!
interface TenGigabitEthernet 1/6/1
no ip address
switchport
switchport mode private-vlan host
no shutdown
!
interface TenGigabitEthernet 1/25/1
no ip address
switchport
switchport mode private-vlan trunk
no shutdown
!
interface Vlan 4000
private-vlan mode primary
private-vlan mapping secondary-vlan 4001-4003
no ip address
tagged TenGigabitEthernet 1/3/1,25/1
no shutdown
!
interface Vlan 4001
private-vlan mode community
654 Private VLANs (PVLAN)
Q Ports
T Te 1/19/1-2