Additional Vlt Sample Configurations - Dell S6100 Configuration Manual

Configured hello time 2, max age 20, forward delay 15
Interface
Name PortID Prio Cost
---------- -------- ---- ------- -------- - ------- -------------
Po 1 128.2 128 200000 DIS
Po 3 128.4 128 200000 DIS
Po 4 128.5 128 200000 DIS
Po 100 128.101 128 800
Po 110 128.111 128 00
Po 111 128.112 128 200000 DIS(vlt) 0
Po 120 128.121 128 2000

Additional VLT Sample Configurations

To configure VLT, configure a backup link and interconnect trunk, create a VLT domain, configure a backup link and interconnect trunk, and
connect the peer switches in a VLT domain to an attached access device (switch or server).
Review the following examples of VLT configurations.
Configuring Virtual Link Trunking (VLT Peer 1)
Enable VLT and create a VLT domain with a backup-link and interconnect trunk (VLTi).
Dell_VLTpeer1(conf)#vlt domain 999
Dell_VLTpeer1(conf-vlt-domain)#peer-link port-channel 100
Dell_VLTpeer1(conf-vlt-domain)#back-up destination 10.11.206.35
Dell_VLTpeer1(conf-vlt-domain)#exit
Configure the backup link.
Dell_VLTpeer1(conf)#interface ManagementEthernet 1/1
Dell_VLTpeer1(conf-if-ma-1/1)#ip address 10.11.206.23/
Dell_VLTpeer1(conf-if-ma-1/1)#no shutdown
Dell_VLTpeer1(conf-if-ma-1/1)#exit
Configure the VLT interconnect (VLTi).
Dell_VLTpeer1(conf)#interface port-channel 100
Dell_VLTpeer1(conf-if-po-100)#no ip address
Dell_VLTpeer1(conf-if-po-100)#channel-member fortyGigE 1/5,6
Dell_VLTpeer1(conf-if-po-100)#no shutdown
Dell_VLTpeer1(conf-if-po-100)#exit
Configure the port channel to an attached device.
Dell_VLTpeer1(conf)#interface port-channel 110
Dell_VLTpeer1(conf-if-po-110)#no ip address
Dell_VLTpeer1(conf-if-po-110)#switchport
Dell_VLTpeer1(conf-if-po-110)#channel-member fortyGigE 1/8
Dell_VLTpeer1(conf-if-po-110)#no shutdown
Dell_VLTpeer1(conf-if-po-110)#vlt-peer-lag port-channel 110
Dell_VLTpeer1(conf-if-po-110)#end
Verify that the port channels used in the VLT domain are assigned to the same VLAN.
Dell_VLTpeer1# show vlan id 10
Codes: * - Default VLAN, G - GVRP VLANs, P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack, H - Hyperpull tagged
NUM Status Description Q Ports
10 Active
Configuring Virtual Link Trunking (VLT Peer 2)
Designated
Sts Cost Bridge ID PortID
0 0 0001.e88a.dff8 128.2
0 0 0001.e88a.dff8 128.4
0 0 0001.e88a.dff8 128.5
FWD(VLTi)0 0 0001.e88a.dff8 128.101
FWD(vlt) 0 0 0001.e88a.dff8 128.111
0 0001.e88a.dff8 128.112
FWD(vlt) 0 0 0001.e88a.dff8 128.121
U Po110(Fo 1/8)
T Po100(Fo 1/5,6)
Virtual Link Trunking (VLT) 905