Applying Dcb Policies In A Switch Stack; Configure A Dcbx Operation; Dcbx Operation; Dcbx Port Roles - Dell S6100 Configuration Manual

Applying DCB Policies in a Switch Stack

You can apply DCB policies with PFC and ETS configurations to all stacked ports in a switch stack or on a stacked switch.
To apply DCB policies in a switch stack, follow this step.
• Apply the specified DCB policy on all ports of the switch stack or a single stacked switch.
CONFIGURATION mode
dcb-map {stack-unit all | stack-ports all} dcb-map-name

Configure a DCBx Operation

DCB devices use data center bridging exchange protocol (DCBx) to exchange configuration information with directly connected peers
using the link layer discovery protocol (LLDP) protocol.
DCBx can detect the misconfiguration of a peer DCB device, and optionally, configure peer DCB devices with DCB feature settings to
ensure consistent operation in a data center network.
DCBx is a prerequisite for using DCB features, such as priority-based flow control (PFC) and enhanced traffic selection (ETS), to exchange
link-level configurations in a converged Ethernet environment. DCBx is also deployed in topologies that support lossless operation for FCoE
or iSCSI traffic. In these scenarios, all network devices are DCBx-enabled (DCBx is enabled end-to-end). For more information about how
these features are implemented and used, refer to:
• Configure Enhanced Transmission Selection
DCBx supports the following versions: CIN, CEE, and IEEE2.5.
Prerequisite: For DCBx, enable LLDP on all DCB devices.

DCBx Operation

DCBx performs the following operations:
• Discovers DCB configuration (such as PFC and ETS) in a peer device.
• Detects DCB mis-configuration in a peer device; that is, when DCB features are not compatibly configured on a peer device and the
local switch. Mis-configuration detection is feature-specific because some DCB features support asymmetric configuration.
• Reconfigures a peer device with the DCB configuration from its configuration source if the peer device is willing to accept
configuration.
• Accepts the DCB configuration from a peer if a DCBx port is in "willing" mode to accept a peer's DCB settings and then internally
propagates the received DCB configuration to its peer ports.

DCBx Port Roles

To enable the auto-configuration of DCBx-enabled ports and propagate DCB configurations learned from peer DCBx devices internally to
other switch ports, use the following DCBx port roles.
Auto-upstream The port advertises its own configuration to DCBx peers and is willing to receive peer configuration. The port also
propagates its configuration to other ports on the switch.
The first auto-upstream that is capable of receiving a peer configuration is elected as the configuration source. The
elected configuration source then internally propagates the configuration to other auto-upstream and auto-
downstream ports. A port that receives an internally propagated configuration overwrites its local configuration
Data Center Bridging (DCB) 253