Deleting Or Disabling A Port Channel; Load Balancing Through Port Channels; Load-Balancing Method - Dell S6100 Configuration Manual

ip address ip-address mask [secondary]
• ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
• secondary: the IP address is the interface's backup IP address. You can configure up to eight secondary IP addresses.

Deleting or Disabling a Port Channel

To delete or disable a port channel, use the following commands.
• Delete a port channel.
CONFIGURATION mode
no interface portchannel channel-number
• Disable a port channel.
shutdown
When you disable a port channel, all interfaces within the port channel are operationally down also.

Load Balancing Through Port Channels

Dell Networking OS uses hash algorithms for distributing traffic evenly over channel members in a port channel (LAG).
The hash algorithm distributes traffic among Equal Cost Multi-path (ECMP) paths and LAG members. The distribution is based on a flow,
except for packet-based hashing. A flow is identified by the hash and is assigned to one link. In packet-based hashing, a single flow can be
distributed on the LAG and uses one link.
Packet based hashing is used to load balance traffic across a port-channel based on the IP Identifier field within the packet. Load balancing
uses source and destination packet information to get the greatest advantage of resources by distributing traffic over multiple paths when
transferring data to a destination.
Dell Networking OS allows you to modify the hashing algorithms used for flows and for fragments. The load-balance and hash-algorithm
commands are available for modifying the distribution algorithms.

Load-Balancing Method

By default, LAG hashing uses the source IP, destination IP, source transmission control protocol (TCP)/user datagram protocol (UDP) port,
and destination TCP/UDP port for hash computation. For packets without a Layer 3 header, Dell Networking OS automatically uses load-
balance mac source-dest-mac.
Do not configure IP hashing or MAC hashing at the same time. If you configure an IP and MAC hashing scheme at the same time, the MAC
hashing scheme takes precedence over the IP hashing scheme.
To change the IP traffic load-balancing default, use the following command.
• Replace the default IP 4-tuple method of balancing traffic over a port channel.
CONFIGURATION mode
[no] load-balance {ip-selection [dest-ip | source-ip]} | {mac [dest-mac | source-dest-mac |
source-mac]} | {tcp-udp enable} {ipv6-selection} {tunnel}| {ingress-port}
You can select one, two, or all three of the following basic hash methods:
• ip-selection [dest-ip | source-ip] — Distribute IP traffic based on the IP destination or source address.
• mac [dest-mac | source-dest-mac | source-mac] — Distribute IPV4 traffic based on the destination or source MAC
address, or both, along with the VLAN, Ethertype, source module ID and source port ID.
Interfaces 373