Dell S6100 Configuration Manual page 643

6
no disable
The following example shows an ERPM configuration:
Dell(conf)#monitor session 0 type erpm
Dell(conf-mon-sess-0)#source tengigabitethernet 1/1/1/1 direction rx
Dell(conf-mon-sess-0)#source port-channel 1 direction tx
Dell(conf-mon-sess-0)#erpm source-ip 1.1.1.1 dest-ip 7.1.1.2 gre-protocol 111
Dell(conf-mon-sess-0)#no disable
Dell(conf)#monitor session 1 type erpm
Dell(conf-mon-sess-1)#source vlan 11 direction rx
Dell(conf-mon-sess-1)#erpm source-ip 5.1.1.1 dest-ip 3.1.1.2 gre-protocol 139
Dell(conf-mon-sess-1)#flow-based enable
Dell(conf-mon-sess-1)#no disable
Dell# show monitor session
SessID Source Destination
FcMonitor Status
------ ------ -----------
--------- -------
0 Te 1/1/1/1 remote-ip
No Enabled
0 Po 1
No Enabled
1 Vl 11
No Enabled
The next example shows the configuration of an ERPM session in which VLAN 11 is monitored as the source interface and a MAC ACL
filters the monitored ingress traffic.
Dell(conf)#mac access-list standard flow
Dell(config-std-macl)#seq 5 permit 00:00:0a:00:00:0b count monitor
Dell#show running-config interface vlan 11
!
interface Vlan 11
no ip address
tagged TenGigabitEthernet 1/1/1/1-1/1/1/3
mac access-group flow in
shutdown
Dir Mode
--- ----
rx Port
remote-ip tx Port
remote-ip rx Flow
<<<<<<<<<<<<<< Only ingress packets are supported for mirroring
Enter the no disable command to enable the ERPM
session.
Source IP Dest IP
--------- -------- ---- --- ---- ---- ------------
1.1.1.1 7.1.1.2
1.1.1.1 7.1.1.2
5.1.1.1 3.1.1.2
DSCP TTL Drop Rate Gre-Protocol
0 255 No 100
0 255 No 100
0 255 No 100
111
111
139
Port Monitoring 643