Specifying Source-Active Messages - Dell S6100 Configuration Manual

Figure 89. MSDP Default Peer, Scenario 4

Specifying Source-Active Messages

To specify messages, use the following command.
• Specify the forwarding-peer and originating-RP from which all active sources are accepted without regard for the RPF check.
CONFIGURATION mode
ip msdp default-peer ip-address list
If you do not specify an access list, the peer accepts all sources that peer advertises. All sources from RPs that the ACL denies are
subject to the normal RPF check.
Example of the ip msdp default-peer Command and Viewing Denied Sources
Dell(conf)#ip msdp peer 10.0.50.2 connect-source Vlan 50
Dell(conf)#ip msdp default-peer 10.0.50.2 list fifty
Dell(conf)#ip access-list standard fifty
Dell(conf)#seq 5 permit host 200.0.0.50
Dell#ip msdp sa-cache
MSDP Source-Active Cache - 3 entries
Multicast Source Discovery Protocol (MSDP) 527