Configuring Management Vrf; Configuring A Static Route - Dell S6100 Configuration Manual

On system
Hide thumbs Also See for S6100:
Table of Contents

Advertisement

Task

Configuring Management VRF

You can assign a management interface to a management VRF.
1
Create a management VRF.
CONFIGURATION
ip vrf management
2
Assign a management port to a management VRF.
VRF MODE
interface management
When Management VRF is configured, the following interface range or interface group commands are disabled:
ipv6 nd dad — Duplicated Address Detection
ipv6 nd dns-server — Configure DNS distribution option in RA packets originated by the router
ipv6 nd hop-limit — Set hop limit advertised in RA and used in IPv6 data packets originated by the router
ipv6 nd managed-config-flag — Hosts should use DHCP for address config
ipv6 nd max-ra-interval — Set IPv6 Max Router Advertisement Interval
ipv6 nd mtu — Configure MTU advertisements in RA packets
ipv6 nd other-config-flag — Hosts should use DHCP for non-address config
ipv6 nd prefix — Configure IPv6 Routing Prefix Advertisement
ipv6 nd ra-guard — Configure IPv6 ra-guard
ipv6 nd ra-lifetime — Set IPv6 Router Advertisement Lifetime
ipv6 nd reachable-time — Set advertised reachability time
ipv6 nd retrans-timer — Set NS retransmit interval used and advertised in RA
ipv6 nd suppress-ra — Suppress IPv6 Router Advertisements
ipv6 ad <ipv6-address> — IPv6 Address Detection
ipv6 ad autoconfig — IPv6 stateless auto-configuration
ipv6 address <ipv6-address> — Configure IPv6 address on an interface
NOTE:
The command line help still displays relevant details corresponding to each of these commands. However, these interface
range or interface group commands are not supported when Management VRF is configured.

Configuring a Static Route

Configure a static route that points to a management interface.
CONFIGURATION
Command Syntax
10.1.1.1 (local)
Hold Down: 0 sec, Preempt: TRUE,
AdvInt: 1 sec
Adv rcvd: 0, Bad pkts rcvd: 0, Adv
sent: 43, Gratuitous ARP sent: 0
Virtual MAC address:
00:00:5e:00:01:0a
Virtual IP address:
10.1.1.100
Authentication: (none)
Command Mode
Virtual Routing and Forwarding (VRF)
935

Advertisement

Table of Contents
loading

Table of Contents