Creating A Vlt Lag Or A Vlt Vlan - Dell S6100 Configuration Manual
On system
Hide thumbs
Also See for S6100:
- Configuration manual (1743 pages) ,
- Installation manual (54 pages) ,
- Release notes (13 pages)
Table of Contents
Advertisement
isolation between ports within the same VLAN. A PVLAN partitions a traditional VLAN into subdomains identified by a primary and
secondary VLAN pair. With VLT being a Layer 2 redundancy feature, support for configuration of VLT nodes in a PVLAN enables Layer 2
security functionalities to be achieved. This section describe how to configure a VLT VLAN or a VLT LAG (VLTi link) and assign that VLT
interface to a PVLAN.
Creating a VLT LAG or a VLT VLAN
1
Configure the port channel for the VLT interconnect on a VLT switch and enter interface configuration mode
CONFIGURATION mode
interface port-channel id-number.
Enter the same port-channel number configured with the peer-link port-channel command as described in
Creating a VLT
Domain.
NOTE:
To be included in the VLTi, the port channel must be in Default mode (no switchport or VLAN assigned).
2
Remove an IP address from the interface.
INTERFACE PORT-CHANNEL mode
no ip address
3
Add one or more port interfaces to the port channel.
INTERFACE PORT-CHANNEL mode
channel-member interface
interface: specify one of the following interface types:
•
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/slot/port[/subport] information.
•
For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/slot/port/subport information.
•
For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the stack/slot/port information.
4
Ensure that the port channel is active.
INTERFACE PORT-CHANNEL mode
no shutdown
5
To configure the VLT interconnect, repeat Steps 1–4 on the VLT peer switch.
6
Enter VLT-domain configuration mode for a specified VLT domain.
CONFIGURATION mode
vlt domain domain-id
The range of domain IDs is from 1 to 1000.
7
Enter the port-channel number that acts as the interconnect trunk.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number
8
(Optional) To configure a VLT LAG, enter the VLAN ID number of the VLAN where the VLT forwards packets received on the VLTi
from an adjacent peer that is down.
VLT DOMAIN CONFIGURATION mode
peer-link port-channel id-number peer-down-vlan vlan interface number
912
Virtual Link Trunking (VLT)
Enabling VLT and
Advertisement
Table of Contents
Troubleshooting
