Specifying Source-Active Messages - Dell Z9500 Configuration Manual

Z-series core and aggregation switche

Hide thumbs Also See for Z9500:

Table of Contents

Figure 92. MSDP Default Peer, Scenario 4

Specifying Source-Active Messages

To specify messages, use the following command.

Specify the forwarding-peer and originating-RP from which all active sources are accepted without regard for the RPF

CONFIGURATION mode

ip msdp default-peer ip-address list

If you do not specify an access list, the peer accepts all sources that peer advertises. All sources from RPs that the ACL

denies are subject to the normal RPF check.

Example of the ip msdp default-peer Command and Viewing Denied Sources

Dell(conf)#ip msdp peer 10.0.50.2 connect-source Vlan 50

Dell(conf)#ip msdp default-peer 10.0.50.2 list fifty

Dell(conf)#ip access-list standard fifty

Dell(conf)#seq 5 permit host 200.0.0.50

Dell#ip msdp sa-cache

Multicast Source Discovery Protocol (MSDP)