Specifying Source-Active Messages - Dell S4820T Configuration Manual

Figure 88. MSDP Default Peer, Scenario 4

Specifying Source-Active Messages

To specify messages, use the following command.
• Specify the forwarding-peer and originating-RP from which all active sources are accepted without
regard for the RPF check.
CONFIGURATION mode
ip msdp default-peer ip-address list
If you do not specify an access list, the peer accepts all sources that peer advertises. All sources from
RPs that the ACL denies are subject to the normal RPF check.
Multicast Source Discovery Protocol (MSDP)
631