Operating Instructions; Precautions For Using Sw3Rn-Gsv43P - Mitsubishi Electric MELSEC System Q Installation Manual

3. INSTALLATION AND UNINSTALLATION
3.4

Operating Instructions

3.4.1

Precautions for Using SW3RN-GSV43P

To use GSV43P, you need to make environment setting in the "Config.nt" or "Con-
fig.sys" file.
Before using GSV43P, always set the "Config.nt" or "Config.sys" file for the fol-
lowing data.
If you do not make the setting in the "Config.nt" or "Config.sys" file, GSV43P will
not run properly.
(1) For Windows NT/2000
Windows NT/2000 requires the following data in the "Config.nt" file. "Config.nt"
is found in the following location.
Drive C Winnt
Depends on the drive set at installation.
• Config.nt
EMM=RAM
dos=high, umb
device=%SystemRoot%\system32\himem.sys
FILES=20
devicehigh=%SystemRoot%\system32\ansi.sys
(2) For Windows 98
Windows 98 requires the following data in the "Config.sys" file. "Config.sys" is
found in the following location.
Drive C Config.sys
• Config.sys
DOS=HIGH,UMB
device=c:\windows\himem.sys
device=c:\windows\EMM386.EXE RAM
devicehigh=c:\windows\command\ansi.sys
System32 Config.nt
3 − 17