Setting The A10Bd-Pcf Interface Board - Mitsubishi Electric MELSEC System Q Installation Manual

4. SSCNET COMMUNICATION DRIVERS
4.3.2

Setting the A10BD-PCF Interface Board

This section explains the switch setting of the A10BD-PCF interface board.
CON1port
CON2port
(1) Board ID setting switch (SW1)
When there are two or more PCI type A10BD-PCF's, set the ID numbers to
identify the respective A10BD-PCF's.
SW2, SW3
1
2
3
4
1) Board ID bit choices 0 to 2 (SW1-1 to 3) and ID numbers
Table 4.2 ID Numbers
Switch Numbers
1 2
BDID0 BDID1
OFF OFF
ON OFF
OFF ON
ON ON
(2) Reset switch (SW2)
Turn on the reset switch (SW2) to reset the A10BD-PCF.
Do not press the reset switch during communication since doing so will shut off
communication.
If normal communication cannot be made, press the reset switch to reset the
A10BD-PCF and then start communication.
LED SW1
LED1
LED2
Definition Default
Board ID bit 0
OFF
(BDID0)
Board ID bit 1
OFF
(BDID1)
Board ID bit 2
OFF
(BDID2)
Controller setting
ON
(MODE)
3 Board ID
BDID2
OFF 0
OFF 1
OFF 2
OFF 3
4 − 11
SW2
Remarks
Set the ID number.
For details, refer to the following
Table 4.2.
Always set to ON.