Mitsubishi Electric MELSEC System Q Installation Manual page 78

4. SSCNET COMMUNICATION DRIVERS
(9) Adjusting the CH. 1 transient driver
When not using CH. 1, you need not adjust the CH. 1 transient driver. Proceed
to "(11) Restarting the personal computer".
(a) Adjust the CH. 1 transient driver in the procedure as in "(7) Adjusting the
CH. 0 transient driver".
Note that "SNETP DRIVER (Transient CH. 1)" should be selected in the
"System Properties" window.
(b) Set the memory range for CH. 1 transient driver adjustment to the value set
for the CH. 0 memory range plus "1000".
(example)
When the CH. 0 value is "000D0000-000D0FFF", set the CH. 1 transient
driver value to "000D1000-000D1FFF".
(10) Adjusting the CH. 1 cyclic driver
When not using CH. 1, you need not adjust the CH. 1 cyclic driver. Proceed to
"(11) Restarting the personal computer".
(a) Adjust the CH. 1 cyclic driver in the procedure as in "(7) Adjusting the CH.
0 transient driver".
Note that "SNETP DRIVER (Cyclic CH. 1)" should be selected in the
"System Properties" window.
(b) Set the memory range for CH. 1 cyclic driver adjustment to the same value
as the memory range of the CH. 1 transient driver.
(11) Restarting the personal computer
After all settings are over, click [Close] in "System Properties" to close the
window.
Click [Shut Down] in the Start menu to restart the personal computer.
(12) Memory Base Addresses of SSCNET Communication Driver Setup and
Memory Ranges of Drivers
Memory Base Memory Range of
Address Refresh Driver
C0000 C0000h to C1FFFh
C4000 C4000h to C5FFFh
C8000 C8000h to C9FFFh
CC000 CC000h to CDFFFh
D0000 D0000h to D1FFFh
D4000 D4000h to D5FFFh
D8000 D8000h to D9FFFh
DC000 DC000h to DDFFFh
Memory Ranges of Transient/Cyclic Driver
CH.0
C0000h to C0FFFh
C4000h to C4FFFh
C8000h to C8FFFh
CC000h to CCFFFh
D0000h to D0FFFh
D4000h to D4FFFh
D8000h to D8FFFh
DC000h to DCFFFh
4 − 25
CH.1
C1000h to C1FFFh
C5000h to C5FFFh
C9000h to C9FFFh
CD000h to CDFFFh
D1000h to D1FFFh
D5000h to D5FFFh
D9000h to D9FFFh
DD000h to DDFFFh