Mitsubishi Electric MELSEC System Q Installation Manual page 73

4. SSCNET COMMUNICATION DRIVERS
To next page
(6) Adjusting the fast refresh driver
Adjust the IRQ and occupied addresses of the SSCNET communication drivers
to the data assigned in detail setting of "SSCNET Communication Driver
Setup".
The following example assumes that the following assignment was made in
detail setting of "SSCNET Communication Driver Setup".
(Example)
• IRQ..................................... 11
• Memory Base Address....... D0000
SSCNET Communication Driver
Setup window
1) Choose and right-click the My Computer icon on the
desktop.
The pop-up menu appears.
Click [Properties] from the pop-up menu.
2) The "System Properties" window appears.
Click [Device Manager].
Choose and double-click "Other devices".
You can confirm the interface board drivers
registered in (1) to (5).
• SNETP DRIVER (Transient CH. 0)
• SNETP DRIVER (Cyclic CH. 0)
• SNETP DRIVER (Transient CH. 1)*
• SNETP DRIVER (Cyclic CH. 1)*
• SNETP DRIVER (Fast Fresh: A30BD-PCF Board)
*Displayed only when CH.1 is registered in driver
registration.
When CH. 1 is not used, these drivers are not
registered and are not shown.
Here, choose "SNETP DRIVER (Fast Fresh: A30BD-
PCF Board)" and click [Properties].
4 − 20