Mitsubishi Electric MELSEC System Q Installation Manual page 74

4. SSCNET COMMUNICATION DRIVERS
From preceding page
To next page
3) The "SNETP DRIVER (Fast Fresh: A30BD-PCF
Board) Properties" window appears.
Click [Resources] and confirm the interrupt request
and memory range.
• Adjustment is not needed if the settings are the
same as in "SSCNET Communication Driver
Setup".
Click [OK].
• If the settings differ from the "SSCNET
Communication Driver Setup" data, choose the
type of the resource to be changed and click
[Change Setting...].
4) If the interrupt request (IRQ Level) differs, choose
"Interrupt request" to highlight it, and click [Change
Setting...].
5) The "Edit Interrupt Request" window appears.
Type "11" in the Value field and click [OK].
6) If the memory range (Memory Base Address) differs,
choose "Memory range" to highlight it, and click
[Change Setting...].
4 − 21