Mitsubishi Electric MELSEC System Q Installation Manual page 72

4. SSCNET COMMUNICATION DRIVERS
(3) Registering the CH. 0 cyclic driver
(4) Registering the CH. 1 transient driver
(5) Registering the CH. 1 cyclic driver
1) Register the CH. 0 cyclic driver in the procedure as
in "(2) Registering the CH. 0 transient driver".
Note that "SNETP DRIVER (Cyclic CH. 0)" should be
chosen as Model in the hardware maker and model
selection window.
1) When not using CH. 1, you need not make this
setting.
Proceed to "(6) Adjusting the fast refresh driver".
Register the CH. 1 transient driver in the procedure
as in "(2) Registering the CH. 0 transient driver".
Note that "SNETP DRIVER (Transient CH. 1)"
should be chosen as Model in the hardware maker
and model selection window.
1) When not using CH. 1, you need not make this
setting.
Proceed to "(6) Adjusting the fast refresh driver".
Register the CH. 1 cyclic driver in the procedure as
in "(2) Registering the CH. 0 transient driver".
Note that "SNETP DRIVER (Cyclic CH. 1)" should be
chosen as Model in the hardware maker and model
selection window.
4 − 19