Arctic Cat 650 Twin2004 Service Manual page 120

5. Connect a signal oscillator (A) to the battery
negative post and the output to terminal (13); then
set the oscillator frequency to 620 Hz. The
speedometer should read approximately 40 mph.
6. Leave the wires connected as in step 5 and press
the MODE button (A) to cycle to the odometer
(B); then increase the frequency of the oscillator.
The odometer should start to count faster.
7. Depress the MODE button (A) and cycle to trip
meters A and B (B); then check the function of
both trip meters in the same manner as the
odometer. Disconnect the oscillator.
ATV2123
8. Connect the wires in the same manner as step 1;
the first segment LCD (A) should flash.
9. Connect a jumper wire from the negative battery
terminal to terminal (3) on the connector. When
connected, one segment in the fuel gauge should
ATV2208C
appear every 15 seconds.
ATV2125
ATV2126
5
ATV2127
ATV2208D
5-19