Accessory Receptacle/Connector; Brakelight Switch (Auxiliary) - Arctic Cat 650 Twin2004 Service Manual

Accessory
Receptacle/Connector

NOTE: This test procedure is for either the
receptacle or the connector.
VOLTAGE
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red tester lead to the red/white wire or
the positive connector; then connect the black
tester lead to ground.
3. The meter must show battery voltage.

NOTE: If the meter shows no battery voltage,
troubleshoot the battery, fuse, receptacle, connec-
tor, or the main wiring harness.
Brakelight Switch
(Auxiliary)
The switch connector is the two-prong connector on
the right side of the engine directly above the brake
cable adjuster.

NOTE: The ignition switch must be in the ON
position.
VOLTAGE
(Wiring Harness Side)
1. Set the meter selector to the D.C. Voltage position.
2. Connect the red tester to the orange wire; then
connect the black tester lead to ground.
3. The meter must show battery voltage.

NOTE: If the meter shows no battery voltage,
troubleshoot the battery, fuse, switch, or the main
wiring harness.

NOTE: If the meter shows battery voltage, the
main wiring harness is good; proceed to test the
switch/component, the connector, and the switch
wiring harness for resistance.
RESISTANCE
(Switch Connector)
Always disconnect the battery when performing
AR606D
resistance
multimeter.
1. Set the meter selector to the OHMS position.
2. Connect the red tester lead to one black wire; then
connect the black tester lead to the other black
wire.
3. When the brake pedal is depressed, the meter must
show less than 1 ohm.

NOTE: If the meter shows more than 1 ohm of
r e s i s t a n c e , t r o u b l e s h o o t o r r e p l a c e t h e
switch/component, the connector, or the switch
wiring harness.
! CAUTION
tests to avoid damaging
AR627D
5
the
AR626D
5-3