Arctic Cat 650 Twin2004 Service Manual page 81

8. Install all exhaust system heat shields and tighten
the mounting screws securely; then install two
muffler mounts, hardware, and bolts and tighten
securely.
9. Install the two upper and one lower coolant hoses
and tighten the hose clamps securely. Make sure to
install the two coolant hoses connected to the
carburetors.
3-52
10. Remove the tape or caps from the intake hoses
checking for any dirt, hardware items, or liquids;
then install the carburetors into the intake hoses
and tighten the clamps securely. Make sure the
carburetors are securely seated by rocking side to
side after installation.
Make sure to check intake hoses for any foreign
matter. Severe engine damage will occur if
liquids or hardware items are ingested at
start-up.
KX141
KX123
11. Connect the throttle cable and check for proper
free-play; then install the cover and tighten the
screw securely.
KX126
12. Install the electronics mounting tray with the CDI,
starter relay, and EBC module attached; then
secure with four mounting screws.
KX086B
! CAUTION
KX122
KX123
KX136