Arctic Cat 650 Twin2004 Service Manual page 44

7. Remove the spacer (A), idler gear assembly (B),
and washers and spacer (C); then remove low and
high range gears (D).
8. Remove the two needle bearings (A); then using a
press, remove the driven shaft (B).

NOTE: Check all parts including gears, shifter,
gear dogs, and splines. Replace chipped, dam-
aged, or worn parts.
KX266
9. Check angle (A) for shift fork bending. It must be
90°.
KX267
10. Measure the thickness of the shift fork at (A); then
measure the shifter groove width (B). If they are
out of specification, they must be replaced.
KX268
REMOVING OUTPUT
DRIVE/DRIVEN BEVEL GEAR
ASSEMBLY
1. Remove the oil pipe, cap screws (A), and the
output drive bevel gear cover (B).
KX269
3
ATV2069
KX270
3-15