Tires - Arctic Cat 650 Twin2004 Service Manual

To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by removing in turn
the drain plug from each.
0736-568
4. After all the oil has been drained, install the drain
plugs and tighten to 0.5 kg-m (3.5 ft-lb).
5. Pour the appropriate amount of recommended oil
into each filler hole.
6. Install the filler plugs. Tighten to 2.2 kg-m (16
ft-lb).

NOTE: If the differential/rear drive oil is contami-
nated with water, inspect the drain plug, filler plug,
and/or bladder.
737-686A
Water entering the outer end of the axle will not
be able to enter the rear drive unless the seals
are damaged.
TIRE SIZES
The ATV is equipped with low-pressure tubeless tires
of the size and type listed. Do not under any circum-
stances substitute tires of a different type or size.
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.
TIRE INFLATION PRESSURE
KX396A
Front and rear tire inflation pressure should be 0.35
kg-cm² (5.0 psi).
A low-pressure gauge is provided in the tool kit to
measure the air pressure in the tires. Check the air
pressure in all tires before each use of the ATV.
! CAUTION

Tires

! WARNING
KX395A
2
2-11