Arctic Cat 650 Twin2004 Service Manual page 29

2. If belt width is below the service limit of 28.8 mm
(1.13 in.) or there is damage to the belt, it must be
replaced.
INSTALLING

NOTE: Be sure to install the belt in the same
direction as originally installed. When installing a
new belt, direct the top of the lettering (A) toward
the engine.
1. Loop the belt (B) over the driven pulley (C); then
install the drive cluch and tighten to spcifications.

NOTE: Make sure the belt is at the top of the
driven pulley (A) before checking belt deflection.
2. Place a straightedge (B) on top of the belt between
the drive clutch (C) and the driven pulley (D); then
using a ruler, check the belt deflection (A). Use a
maximum force of 6 kg (13 lb) on the ruler. Stan-
dard belt deflection is 22-27 mm (0.87-1.06 in.). If
belt deflection is out of specifications, see Section
3, Right-Side Components.
2-20
3. Check the position of the Belt Failure Detection
Switch (A) and reset to the ON position (B).
KX232

NOTE: If the Belt Failure Detection Switch has
been tripped to the OFF position, the V-belt cover
and switch assembly must be replaced and the
V-Belt Failure Mode Clearing procedure (see Sec-
tion 5) must be performed.
4. Install the cover seal into the V-belt cover with the
glue joint (A) as shown; then install the V-belt
cover and tighten the cap screws to specifications.
KX233
5. Connect the actuator lead and the Belt Failure
Detection Switch lead; then install the air duct and
secure with the clamps.
ATV2061
ATV2062A
ATV2063