Arctic Cat 650 Twin2004 Service Manual page 66

14. Apply clean engine oil to the shift rod (A), shift
fork (B), and needle bearing (C); then install the
shift rod with shifter, spacer (D), and needle
bearing.
15. Install the reverse drive gear (A) and spacer (B);
then install the reverse idler (C).
KX316
16. Apply molybdenum disulfide oil to the shift shaft
(A); then install the shift spring (C) and guide (D).
Apply red Loctite #271 to the shift shaft spring
bolt (B) and tighten to 2.5 kg-m (18 ft-lb).
KX317
17. Make sure that the crankshaft, transmission shafts
and shift shaft (A), oil tube (B), oil screen (C),
O-ring (D), and alignment pins (E) are in place in
the right crankcase half; then apply clean engine
oil to the moving parts and grease to all O-rings
and seals.
KX318
KX319A
3
KX320
KX321
3-37