Front Fender/Side Panels - Arctic Cat 650 Twin2004 Service Manual

Front Fender/
Side Panels
REMOVING
1. Remove the front rack (see Front Rack in this
section).
2. Remove the three cap screws securing the two side
panels to the frame and rear fenders; then remove
the side panels.
3. Using a small flat-blade screwdriver, carefully
remove the retaining pin securing the gear shift
knob to the shift lever; then remove the knob from
the lever.
4. Remove the three machine screws securing the
gear shift linkage cover to the fender and remove
the cover.

NOTE: The cover is located inside the left-front
wheel well.
5. Remove the nut securing the drive selector
linkage. Account for a washer and bushing.
8-12
6. Remove the six cap screws securing the fender to
the frame.
CC852
7. Remove the four cap screws and nuts securing the
fender to the footrests.
CC851
CC853
CC854A
CC855
CC861A