Arctic Cat 650 Twin2004 Service Manual page 69

14. Apply grease to the output drive oil seal; then
install in the housing being careful not to damage
the lip of the seal or distort the seal.
15. Secure the holding fixture (A) in a vise; then
install the driven bevel gear (C), cam damper (D),
spring (E), spring holder (B), and circlip (G).
16. Install the guide bars (A), spring compressor (B),
and nuts (C); then tighten the nuts (C) until the
circlip (D) can be installed. After seating the
circlip, remove the nuts (C), compressor (B), and
guide rods (A). Apply grease to the O-ring seal on
the housing.
3-40
KX328
17. Install the driven gear assembly (B) in the
crankcase; then tighten the four cap screws (A) to
2.7 kg-m (19.5 ft-lb).
18. Install the drive bevel gear housing (B); then
tighten the four cap screws (A) to 2.7 kg-m (19.5
ft-lb).
KX329A

NOTE: If any of the output bevel gear (backlash-
related) parts have been replaced, the Adjusting
Backlash and Adjusting Tooth Contact procedures
must be followed.
KX330
KX331A
KX332
KX333