Arctic Cat 650 Twin2004 Service Manual page 82

13. Connect the four disconnect plugs as shown; then
connect the battery positive cable and starter lead
to the starter relay.
14. Connect the starter cable to the starter lug and
tighten securely.
15. Connect the alternator and pick-up coil leads; then
attach the reverse indicator lead and neutral
indicator lead to the switches.
16. Connect the speed sensor, forward/reverse sensor
lead, and oil pressure warning lead; then connect
the drive belt failure detector lead and the engine
brake control servo lead to the main harness.
Connect the spark plug wires.
17. Remove the tape from the carburetor inlets
checking for any foreign material; then using red
Loctite #271, install the lower air cleaner housing
and tighten the mounting screws securely.
18. Install the air filter and air filter cover.
KX130
KX074
19. Install the left footrest; then tighten the 10 mm cap
screws to 5.5 kg-m (40 ft-lb) and the 8 mm cap
screws to 2.8 kg-m (20 ft-lb).
20. Install all fenders, side panels, and racks that were
removed; then install the storage compartment
cover.
21. Install the battery by connecting the positive cable
first; then connecting the negative cable.
22. Install the seat making sure it is properly secured.
KX075B
23. Fill with recommended oil and coolant. See
Section 2.
3
KX119
KX118
3-53