Switches; Accessory Receptacle/Connector; Brakelight Switch - Arctic Cat PROWLER HDX 2015 Service Manual


NOTE: The maintainer/charger will charge the battery
to 95% capacity at which time the Maintenance Charge
Indicator (D) will illuminate and the maintainer/charger
will change to pulse/float maintenance. If the battery
falls below 12.9 DC volts, the charger will automatically
start again at the first step of the charge sequence.

NOTE: Not using a battery charger with the proper
float maintenance will damage the battery if con-
nected over extended periods.
Charging

NOTE: Arctic Cat recommends the use of the CTEK
Multi US 800 or the CTEK Multi US 3300 for battery
maintenance charging.
1. Be sure the battery and terminals have been cleaned
with a baking soda and water solution.
2. Be sure the charger and battery are in a well-venti-
lated area and ensure the battery charger cables will
not contact any battery acid. Be sure the charger is
unplugged from the 110-volt electrical outlet.
3. Connect the red terminal lead from the charger to the
positive terminal of the battery; then connect the
black terminal lead of the charger to the negative ter-
minal of the battery.
4. Plug the charger into a 110-volt electrical outlet.
5. By pushing the Mode button (A) on the left side of
the charger, select the Normal Charge Icon (E). The
Normal Charge Indicator (C) should illuminate on
the upper left portion of the charger.
6. The battery will charge to 95% of its capacity at
which time the Maintenance Charge Indicator (D)
will illuminate.

NOTE: For optimal charge and performance, leave the
charger connected to the battery for a minimum 1 hour
after the Maintenance Charge Indicator (D) illuminates.
If the battery becomes hot to the touch, stop charging.
Resume after it has cooled.
7. Once the battery has reached full charge, unplug the
charger from the 110-volt electrical outlet.

NOTE: If, after charging, the battery does not perform
to operator expectations, bring the battery to an autho-
rized Arctic Cat dealer for further troubleshooting.
Each time the vehicle is used, switches should be
checked for proper operation. Use the following list
for reference.
A. Ignition/start switch — engine will run; starter
will engage.
B. Drive select switch — differential will engage
(4WD)/disengage (2WD).
C. Reverse/neutral/high/low/park switch — R/N/H/
L/P will be indicated on the LCD.
D. Headlight switch — high beam, low beam, and
lights off can be selected.
E. Brake switch — brakelight illuminates and starter
can be engaged with vehicle in gear.
3300A
Accessory Receptacle/
NOTE: This test procedure is for either the recep-
tacles or the connectors.
VOLTAGE
1. Turn the ignition switch to the ON position; then set
the meter selector to the DC Voltage position.
2. Connect the red tester lead to the red/white wire or
the positive connector; then connect the black tester
lead to ground.
3. The meter must show battery voltage.
NOTE: If the meter shows no battery voltage,
troubleshoot the battery, fuse, receptacle, connec-
tor, or the main wiring harness.

Brakelight Switch

Component data can be retrieved using the CATT II. Uti-
lize the Sensor Data screen.
The switch connector is the two-prong black connector
below the master cylinder.
NOTE: The ignition switch must be in the ON
position.

Switches

Connector
129