HP StorageWorks ESL E-Series User Manual page 155

Table 25: Hardware failure ASCQ values
ASCQ
00-0F
OTHER
Hardware internal failure. Call Technical Support.
10-1F
ENCODER/MOTOR
Check the motor/encoder connector.
20-2F
HOME SENSOR/FLAG
Home sensor/flag failure. Check home sensor connector and flag.
30-3F
MECHANICAL POSITION ERROR
Hardware did not reach desired position. The axis path could be obstructed. Determine the
cause of the obstruction. Retry command. If the failure recurs, run self-test.
40-4F
TIMEOUT
Hardware did not reach desired position. The axis rail lubrication may be insufficient. The
axis belt may be too tight. The motor pulley may be loose. Retry the command. If the failure
reoccurs, then run selftest.
50-5F
OVER CONTROL
The hardware is obstructed. Determine the cause of the obstruction. Retry the command. If
the failure reoccurs, then run selftest.
60-6F
FPGA FAILURE
Robotics FPGA has failed. Call Technical Support.
70-7F
POSITIONAL DRIFT
The hardware home position is drifting. Call Technical Support.
80-8F
MAPPING FAILURE
Scanner was unable to detect optical target during calibration.
ESL E-Series Tape Library User's Guide
Description
Sense Data Values
155