Emergency Operation - Panasonic S-36PU1E5A Service Manual

8-11. Emergency Operation

Use [Emergency Operation]
When the remote control's batteries have failed.
When the remote control is broken.
When the remote control is lost.
*1 Figures: CZ-RWSU2, CZ-WRSY2, CZ-RWST2 and CZ-RWST3 are of receivers (inside indoor unit),
CZ-RWSL2 is of the operation panel (inside indoor unit) and Indoor Unit (CZ-RWSK2) is of its front panel.
CZ-RWSU2 / CZ-RWST2 / CZ-RWSY2 / Indoor Unit (CZ-RWSK2) / CZ-RWST3
Start : press [Emergency Operation]
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooling mode.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heating mode.
Stop : press [Emergency Operation]
CZ-RWSU2
Start/Stop
CZ-RWSY2
Start/Stop
NOTE
The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
CZ-RWSC2 / CZ-RWSL2
1. Press [Emergency Operation]
If the indoor temperature is 24 °C or greater when the unit starts running, it will act as a cooling mode.
If the indoor temperature is less than 24 °C when the unit starts running, it will act as a heating mode.
2. If you press , the wind direction automatically oscillates up and down.
Stop : press [Emergency Operation]
CZ-RWSL2
2
NOTE
The Test Run/On and Test/On switches are for use when the unit is installed and test run. It is not for normal use.
If the [Normal/Stop ALL] switch is on Stop ALL, the unit cannot receive signals from the remote control.
in the following situations when there is an urgent need.
of the receiver.
of the receiver again.
CZ-RWST2
Start/Stop
CZ-RWST3
Start/Stop
of the receiver.
of the receiver again.
CZ-RWSC2
1
1
2
8-11
Indoor Unit (CZ-RWSK2)
Start/Stop
8