Installing Batteries - Panasonic S-36PU1E5A Service Manual

8-2. Installing Batteries

1. Remove the cover.
2. Insert two AAA alkaline batteries.
Put the batteries in with the polarity [+/–] as shown in the figure.
3. Gently insert one end of an unfolded paper clip (or a similar object that can
fit) into the Reset hole and press the Reset button inside the hole and then
put the cover back on.
NOTE
Change the batteries when the display of the remote control gets weak or if it will
not work unless close to the receiver.
(Alkaline batteries generally last about one year.)
When changing batteries, always use two fresh batteries of the same make.
If the remote control will not be used for a long period of time, remove the batteries.
Please dispose of batteries appropriately.
After changing the batteries, follow the procedures described below to reset the
current time.
How to remove batteries
1. Remove the cover.
2. Press the battery toward the negative end and lift it out by its positive end.
(As shown at right)
3. Remove the other battery in the same way.
NOTE
Dispose of the used batteries at the designated location in compliance with the
applicable local ordinances.
WARNING
Do not swallow the battery.
After removing the battery from remote control unit, keep it away from the reach of children.
The battery can cause death by suffocation if swallowed.
When inserting the battery, make sure the polarities (+ and -) are correct.
8-3. Setting the Current Time
After changing the batteries and pressing reset, be sure to reset the current time.
(When reset is pressed, the current time reverts to
1. Press for two seconds or more.
Once the clock displays starts blinking, the clock can be set.
2. Set the hour with /
If you press and hold the button, the time changes quickly.
3. Set the minutes with
If you press and hold the button, the time changes quickly.
4. Pressing completes the time setting.
While you are setting the current time, the time display flashes but the colon does not.
If the buttons are not pressed for three minutes while setting the current time,
it is set to the displayed time.
NOTE
When reset is pressed, the timer settings are deleted.
[ ])
of the .
of the
/ .
8-5
Reset hole
Cover
2 3
1,4
8