Panasonic S-36PU1E5A Service Manual page 662

Table of Contents

Advertisement

RECEIVER
1. Receiver
2. Emergency
operation button
3. Operating lamp
4. Timer lamp
5. Standby lamp
6. Filter lamp
7. Swing button
8. Normal/Stop
All switch
8
9. Address switch
NOTE
If a heat pump model is being used, it will beep twice and the operating lamp will light up on the display; if the timer and standby
lamps blink alternately, a conflict between the heating and cooling exists, so the unit cannot operate in the desired mode.
(On models that do not have an Auto function, even if Auto is selected, it works in the same way.)
When the local operation is disabled by such as the centralized control, and if the Start, Stop, Mode or Temperature setting
buttons are pressed, the unit will beep five times and the change will not be made.
Receives the signal sent from the
remote control.
Display lamps
When an error occurs, one of the
lamps flashes. When a display
lamp is blinking, refer to " Before
Requesting Service ".
This lamp is lit when the unit is
operating.
This lamp is lit when the timer is set.
When the heater is working, the
lamp lights at the following times.
When the thermostat has operated
during defrosting at the time of the
startup.
The lamp flashes when an error
occurs.
This lamp is for notifying you when
the filter needs to be cleaned.
Use in the Normal position. It does
not operate in the Stop All position.
Remote control, main / remote
control, secondary, switch
In normal use this should be on
remote control, main. It is also
possible to use both in conjunction
with a wired remote control
(sold separately). (Consult with the
dealer where the product was
purchased about making the
settings.)
Test/On switch
This is used during service. It is not
for normal use.
Test Run/On switch
This is used during service. It is not
for normal use.
Differentiate between incoming and
outgoing signals.
CZ-RWSU2
1
CZ-RWSY2
1
CZ-RWSC2
1
2
7
8
9
3
4
5
6
Indoor Unit (CZ-RWSK2)
8-4
CZ-RWST2
2
1
2
3
4
5
3 4 5
CZ-RWST3
2
2
3
4
5
3
4
5
1
CZ-RWSL2
3 4 5
Display
1
Operation Panel
8 9
7
2
3
4
5
2

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents