Panasonic S-36PU1E5A Service Manual page 310

1
Type K1
Caution
This unit may be used in a single-type refrigerant system where 1 outdoor unit is connected to 1 indoor
unit, and also in a system where 1 outdoor unit is connected to multiple indoor units (maximum 2).
* If multiple indoor units are used, also refer to section "System Control" for Type K1.
The indoor and outdoor unit control PCB utilizes a semiconductor memory element (EEPROM).
The settings required for operation were made at the time of shipment.
Only the correct combinations of indoor and outdoor units can be used.
Test Run Procedure
Turn ON the indoor
and outdoor power
(Automatic Address Setting)
Recheck the items to check before the test run.
Check the combination (wiring) of indoor and outdoor units.
Is system "single-type"?
YES
(1 indoor unit is connected
to 1 outdoor unit)
Are multiple outdoor units used?
Turn ON the indoor and outdoor power.
(Automatic Address Setting)
Set the indoor unit control switch to "TEST".
Can operation
be started?
Slide the indoor unit control
switch back to "ON".
See section "Test Run" for Type K1.
NO
YES
(See section "Setting the outdoor unit
system addresses" for Type K1 to "Indoor
NO
unit address setting".)
See section "Test Run" for Type K1.
See section "Table of Self-Diagnostic
Functions and Corrections (Type K1)" .
Refer to "Table of Self-Diagnostic
NO
Functions" to check the system.
In addition, refer to "System control"
for Type K1 and correct any items
that need to be corrected.
YES
Note: Check the indoor side drainage.
1-300
See section "Items to Check
Before the Test Run" for Type K1.
See section "System Control"
for Type K1.
(See section "Basic wiring
diagram 2" for Type K1.)
In case of group control
Confirm wiring is done in
accordance with "Basic
wiring diagram 2" for Type K1.
How to Set Automatic Address
Set the automatic
address setting
from outside unit.