Panasonic S-36PU1E5A Service Manual page 319

Test Run Procedure
Recheck the items to check before the test run.
Check the combination (wiring) of indoor and outdoor units.
YES
Turn ON the indoor
and outdoor power.
Automatic Address Setting
(*) Indicate (mark) the combination number.
(See section "Checking indoor unit addresses" and "Indicating (marking) the indoor
and outdoor unit combination number" for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
Turn ON the indoor and outdoor power. (Automatic Address Setting)
Is system "single-type"?
NO
Is outdoor unit multiple?
YES
(See section "Setting outdoor unit system addresses"
for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
How to Set the Outdoor Unit System Address
Set the outdoor unit system address.
(See section "Basic wiring diagram"
for Type U1, T2, F1, N1 and Y2 (for Link Wiring).)
How to Set Automatic Address
Set the automatic address setting from
outside unit or remote controller.
Set the remote controller to "test run".
Can operation
be started?
YES
Return the remote controller
to normal control.
1-309
See section "Items to Check Before the
Test Run" for Type U1, T2, F1, N1 and
Y2 (for Link Wiring).
See section "Basic wiring diagram"
for Type U1, T2, F1, N1 and Y2
(for Link Wiring).
NO
See section "Test Run Using the Remote
Controller" for Type U1, T2, F1, N1 and Y2
(for Link Wiring).
See section "Table of Self-Diagnostic Functions
and Corrections (Type U1, T2, F1, N1 and Y2)"
Refer to "Table of Self-Diagnostic
NO
Functions" to check the system.
In addition, refer to section "Automatic
Address Setting" for Type U1, T2, F1, N1
and Y2 (for Link Wiring) and correct any
items that need to be corrected.
Note: Check the indoor side drainage.
(*) Required for simultaneous-operation
multi systems and for group control.
1