Rack Installation Instructions; Safety Precautions - Oracle sun X4-8 Installation Manual

Rack Installation Instructions

This section provides instructions for placing the server into a rack using the shelf rail assembly
in the rack mount kit. Perform these procedures if the rail assembly is purchased.
The Sun Server X4-8 does not have slide rails. Once it is installed in the rack, you cannot slide
it out without uninstalling it. However almost all components can be accessed from the front or
back without uninstalling it.
Note -
Description
Review safety precautions.
Review the compatibility requirements for your rack.
Unpack the server and inventory the contents
Add or remove shipping brackets (optional)
Install the server into a rack.

Safety Precautions

This section describes safety precautions you must follow when installing the server into a rack.
Caution -
bottom up so that the rack does not become top-heavy and tip over. Deploy your rack's anti-tilt
device to prevent the rack from tipping during equipment installation.
In this guide, the term rack means either an open rack or a closed cabinet.
Equipment damage or personal injury. Always load equipment into a rack from the
Links
"Safety Precautions" on page 35
"Rack Compatibility" on page 36
"Unpack the Server and Inventory the
Contents" on page 37
"Install Shipping Bracket (Optional)" on page 45
"Install the Server into the Rack" on page 47
Rack Installation Instructions 35