Oracle sun X4-8 Installation Manual page 58

Modify IPv4 Network Settings From the Oracle ILOM CLI
To modify IPv6 network settings, see
CLI" on page
Note -
the Sun Server X4-8 Service
1. Log in to the Oracle ILOM CLI. See:
"Log In to Oracle ILOM Using a Local Serial Connection" on page 55
■
"Log In to Oracle ILOM Using a Remote Ethernet Connection" on page 55
■
Note -
terminated when you set commitpending to true. When this happens, log back in using the new
settings.
2.
Use the cd command to navigate to the /SP/network directory:
->
cd /SP/network
3. Do one of the following:
If you have a DHCP server on the network, type the following command to
■
view the settings assigned to the server by the DHCP server:
->
■ If there is no DHCP server, or if you want to assign settings, use the set
command to assign values for the properties listed in the following table.
For example:
->
->
->
->
->
58 Sun Server X4-8 Installation Guide • December 2015
60.
You can also change network settings using the BIOS Setup Utility. For instructions, see
Manual.
If you are logged in to Oracle ILOM using an Ethernet connection, your connection is
show /SP/network
set /SP/network/ pendingipdiscovery=static
set /SP/network/ pendingipaddress=192.168.183.106
set /SP/network/ pendingipnetmask=255.255.255.0
set /SP/network/ pendingipgateway=192.168.183.254
set /SP/network/ commitpending=true
"Modify IPv6 Network Settings From the Oracle ILOM