Oracle sun X4-8 Installation Manual page 62

Modify IPv6 Network Settings From the Oracle ILOM CLI
Note -
Note -
option for dhcpv6_stateless or dhcpv6_stateful is enabled. However, the auto-configuration
options for dhcpv6_stateless and dhcpv6_stateful should not be enabled to run at the same
time.
To set a static IPv6 address, complete these steps:
5.
Specify the following property types:
a.
Note -
complete information, see
Servers Administration Guide
goto/ILOM/docs.
Property
state
pendingipaddress
b. Commit the pending IPv6 static network parameters by typing the following
command:
->
Note -
address to the server ends all active Oracle ILOM sessions to the server. To log back in to
Oracle ILOM, create a new session using the newly assigned IP address.
6. Test the IPv6 network configuration from Oracle ILOM using the Network Test
Tool (Ping6).
62 Sun Server X4-8 Installation Guide • December 2015
The IPv6 configuration options take affect after they are set.
You can enable the stateless auto-configuration option to run at the same time as the
These steps do not include all of the network configuration commands. For more
"Configuring Oracle ILOM Network Settings" in Oracle X4 Series
or the Oracle ILOM documentation at
Set Property Value
set state=enabled
set
pending_static_ipaddress
= <ipv6_address> / <subnet
mask length in bits>
set /SP/network/commitpending=true
Pending settings remain pending until you commit them. Assigning a new static IP
http://www.oracle.com/
Description
The IPv6 network state is enabled by default. To
enable a static IP address, you must set this state to
enabled.
Type this command followed by the property value
for the static IPv6 address and netmask that you want
to assign to the device.
IPv6 address example:2001:db8:8:b7:214:4fff:
feca:5f7e/64