Oracle sun X4-8 Installation Manual page 61

ipgateway = 2001:db8:211:5dff:febe:5000/128
pending_static_ipaddress = ::/128
pending_static_ipgateway = ::
dynamic_ipaddress_1 2001:db8:8:b7:214:4fff:feca:5f7e/64
Commands:
cd
show
4.
To configure an IPv6 auto-configuration option, use the set command to specify
the following auto-configuration property values:
Property
state
autoconfig
Set Property Value Description
Use the state parameter to enable or disable IPv6:
set state=enabled
■ enabled: Enable IPv6
■ disabled: Disable IPv6
Note -
ipv4-only or ipv6-only commands. On these versions, you
cannot enable IPv6 if IPv4 is disabled. To obtain the options
shown here, upgrade to SW 1.2 or newer.
set autoconfig= <value> Specify this command followed by the autoconfig value you
want to set.
Options include:
■ stateless (default setting)
■ dhcpv6_stateless
■ dhcpv6_stateful
■ disable
Modify IPv6 Network Settings From the Oracle ILOM CLI
Note - With SW 1.2 or newer, you can use set /SP/
network/state = ipv6-only to enable IPv6 and disable
IPv4.
Older versions of Oracle ILOM do not include the
Automatically assigns IP address learned from IPv6
network router.
Automatically assigns DNS information learned from the
DHCPv6 server.The dhcpv6_stateless property value is
available in Oracle ILOM as of 3.0.14.
Automatically assigns the IPv6 address learned from the
DHCPv6 server.The dhcpv6_stateful property value is
available in Oracle ILOM as of 3.0.14.
Disables all auto-configuration property values and sets the
read-only property value for link local address.
Connecting to Oracle ILOM 61