Oracle sun X4-8 Installation Manual page 59

These steps do not include all of the network configuration commands. For more
Note -
complete information, see
Servers Administration Guide
goto/ILOM/docs.
Property
state
pendingipdiscovery
pendingipaddress
pendingipnetmask
pendingipgateway
commitpending
If you are logged in to Oracle ILOM using an Ethernet connection, your connection is
Note -
terminated when you set commitpending to true. When this happens, log back in using the new
settings.
Modify IPv4 Network Settings From the Oracle ILOM CLI
"Configuring Oracle ILOM Network Settings" in Oracle X4 Series
or the Oracle ILOM documentation at
Set Property Value
set state=enabled
set pendingipdiscovery=static
set
pendingipaddress=<ip_address>
pendingipnetmask=<netmask>
pendingipgateway=<gateway>
set commitpending=true
http://www.oracle.com/
Description
The state parameter modifies both IPv4
and IPv6 as follows:
■ enabled - IPv4 enabled, IPv6
unchanged
Note - To enable IPv6, use /SP/
network/ipv6 state = enabled or
/SP/network/ipv6_only.
■ ipv4_only - IPv4 enabled, IPv6
disabled
■ ipv6_only - IPv4 disabled, IPv6
enabled
■ disabled - ipv4 disabled, IPv6 disabled
Note - Older versions of Oracle ILOM do
not include the ipv4-only or ipv6-only
commands. On these versions, you cannot
enable IPv6 if IPv4 is disabled. To obtain
the options shown here, upgrade to SW 1.2
or newer.
To enable a static network configuration,
set pendingipdiscovery to static.
By default, pendingipdiscovery is set to
dhcp.
To assign multiple static network settings,
type the set command followed by the
pending command for each property
value (IP address, netmask, and gateway),
then type the static value that you want to
assign.
Type set commitpending=true to commit
changes.
Connecting to Oracle ILOM 59