Oracle sun X4-8 Installation Manual page 114

Configure RAID in Legacy Boot Mode
If you want to create a RAID volume level 5, 6, 50, or 60 using the storage drive on which
■
you plan to install the operating system.
Note -
Z HBA.
Create one or more RAID volumes (virtual drives).
1.
Refer to the instructions for creating a storage configuration using the WebBIOS Configuration
Utility in the MegaRAID SAS Software User's Guide located at:
http://www.lsi.com/sep/Pages/oracle/sg_x_sas6-r-rem-z.aspx
Note -
virtual drive bootable. To make a drive bootable, proceed to the next step in this section after
you've created your virtual drive.
2. Make a virtual drive bootable, first power on or reset the host.
For example, to reset the server, do one of the following:
From the local server, press the Power button (approximately 1 second) on the front panel of
■
the server to power off the host, then press the Power button again to power it back on.
From the Oracle ILOM web interface, select Host Management > Power Control, then
■
select Reset from the Select Action list box.
From the Oracle ILOM CLI, type:
■
The BIOS screen appears.
3.
Upon seeing the prompt Press Ctrl><H> for WebBIOS..., immediately press the
Ctrl+H key combination to access the LSI MegaRAID utility.
114 Sun Server X4-8 Installation Guide • December 2015
Oracle System Assistant only supports RAID 0, 1, and 10 for the SGX-SAS6-R-INT-
The MegaRAID SAS Software User's Guide does not include instructions for making a
reset /System