Configuring Eigrp Nsf - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring NSF with SSO Supervisor Engine Redundancy
Interface:GigabitEthernet2/0/0
Interface:Loopback1

Configuring EIGRP NSF

To configure EIGRP NSF, perform this task:
Command
Step 1
Switch# configure terminal
Step 2
Switch(config)# router eigrp as-number
Step 3
Switch(config-router)# nsf
Verifying EIGRP NSF
To verify EIGRP NSF, you must check that the NSF function is configured on the SSO-enabled
networking device. To verify EIGRP NSF, follow these steps:
Verify that "nsf" appears in the EIGRP configuration of the SSO-enabled device by entering the
Step 1
show running-config command:
Switch# show running-config
.
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
13-16
L1 NSF ACK requested:FALSE
L1 NSF CSNP requested:FALSE
NSF L2 Restart state:Running
NSF p2p Restart retransmissions:0
Maximum L2 NSF Restart retransmissions:3
L2 NSF ACK requested:FALSE
NSF L1 Restart state:Running
NSF L1 Restart retransmissions:0
Maximum L1 NSF Restart retransmissions:3
L1 NSF ACK requested:FALSE
L1 NSF CSNP requested:FALSE
NSF L2 Restart state:Running
NSF L2 Restart retransmissions:0
Maximum L2 NSF Restart retransmissions:3
L2 NSF ACK requested:FALSE
L2 NSF CSNP requested:FALSE
NSF L1 Restart state:Running
NSF L1 Restart retransmissions:0
Maximum L1 NSF Restart retransmissions:3
L1 NSF ACK requested:FALSE
L1 NSF CSNP requested:FALSE
NSF L2 Restart state:Running
NSF L2 Restart retransmissions:0
Maximum L2 NSF Restart retransmissions:3
L2 NSF ACK requested:FALSE
L2 NSF CSNP requested:FALSE
Chapter 13 Configuring Cisco NSF with SSO Supervisor Engine Redundancy
Purpose
Enters global configuration mode.
Enables an EIGRP routing process, which places
the switch in router configuration mode.
Enables EIGRP NSF.
Use this command on the "restarting" switch and
all of its peers.