Configuring The Switch For The First Time - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring the Switch for the First Time

This chapter describes how to initially configure the switch.
The information presented here supplements the administration information and procedures in the
Configuration Fundamentals Configuration Guide
Command
This chapter includes the following major sections:
•
•
•
•
•
•
•
•
For complete syntax and usage information for the switch commands used in this chapter, see the
Note
Cisco IOS Command Reference Guides for the Catalyst 4500 Series
If a command is not in the Cisco Catalyst 4500 Series Switch Command Reference , you can locate it in
the
Default Switch Configuration
This section describes the default configurations for the switch.
configuration settings for each feature.
Table 3-1
Feature
Administrative connection
Global switch information
System clock
Reference.
Default Switch Configuration, page 3-1
Configuring DHCP-Based Autoconfiguration, page 3-2
Configuring the Switch, page 3-8
Controlling Access to Privileged EXEC Commands, page 3-13
Recovering a Lost Enable Password, page 3-25
Modifying the Supervisor Engine Startup Configuration, page 3-25
Replacing and Rolling-Back Configuration, page 3-33
Resetting a Switch to Factory Default Settings, page 3-34
Cisco IOS Master Command List, All
Default Switch Configuration
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
C H A P T E R
and the Cisco IOS Configuration Fundamentals
Releases.
Default Settings
Normal mode
No default value for system name, system contact, and location
No value for system clock time
3
Switch.
Table 3-1 shows the default
3-1