Enabling The Netconf Interface - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring Programmability Components

Enabling the NETCONF Interface

This task is mandatory if you want to use the NETCONF interface and have opted for the standard
configuration method:
Command or Action
Step 1 enable
Example:
Switch# enable
Step 2 configure terminal
Example:
Switch# configure terminal
Step 3
netconf-yang
Example:
Switch(config)# netconf-yang
Step 4 end
Example:
Switch# end
See
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
6-12
Examples for NETCONF RPCs, page
Purpose
Enables privileged EXEC mode. Enter your password if
prompted.
Enters the global configuration mode.
Enables the NETCONF interface on your network device.
After you have completed this step, you can manage network
devices through a model based interface. The complete
activation of model-based interface processes may require up to
90 seconds.
Exits global configuration mode and enters privileged EXEC
mode.
6-14.
Chapter 6 Programmability