Configuring Lldp And Lldp-Med, And Location Service - Cisco Catalyst 4500 Series Software Configuration Manual

Configuring LLDP and LLDP-MED, and Location Service

•
•
•
•
•
•
•
•
•
•
Depending on the device capabilities, the switch obtains this client information at link down:
•
•
•
•
•
•
•
•
•
•
If an administrator changes a location address at the switch, the information is reported to the MSE. The
switch sends a NMSP location notification message that identifies the list of ports affected by the change
and the changed address information.
Configuring LLDP and LLDP-MED, and Location Service
This section contains this configuration information:
•
•
•
•
•
•
•
•
•
Catalyst 4500 Series Switch, Cisco IOS Software Configuration Guide - Cisco IOS XE 3.9.xE and IOS 15.2(5)Ex
32-4
Slot, port, and port-type
Client's MAC address
Client's IP address
802.1X username if applicable
Device category is specified as a wired station
State is specified as Connected
Serial number, UDI
Model number
Software version
VLAN ID and VLAN name
Slot and port that was disconnected
Client's MAC address
Client's IP address
802.1X username if applicable
Device category is specified as a wired station
State is specified as Disconnected
Serial number, UDI
Model number
Software version
VLAN ID and VLAN name
Default LLDP Configuration, page 32-5
Configuring LLDP Characteristics, page 32-5
Disabling and Enabling LLDP Globally, page 32-6
Disabling and Enabling LLDP on an Interface, page 32-7
Configuring LLDP-MED TLVs, page 32-9
Configuring Network-Policy Profile, page 32-10
Configuring LLDP Power Negotiation, page 32-11
Configuring Location TLV and Location Service, page 32-12
Monitoring and Maintaining LLDP, LLDP-MED, and Location Service, page 32-14
Chapter 32 Configuring LLDP, LLDP-MED, and Location Service